Engineers at your doorstep · West, South West & South London

Plumbing · 6 min read

Low water pressure in a London home: causes and fixes

Low pressure is a common complaint in London, especially in older terraces and upper-floor flats. The fix depends on the cause.

Pressure vs flow

Pressure is how hard the water pushes, measured in bar. Flow is how much water arrives, measured in litres per minute. You can have decent pressure but poor flow (for example through a narrow lead pipe), and both matter for combi boilers and showers. Water companies’ reference level is around 1 bar (10 metres head) at a flow of 9 litres per minute at your boundary.

Common causes in London

  • A partly closed or seized stopcock. Check it is fully open.
  • Old lead or galvanised supply pipes that are narrow or furred up, common in pre-1970 houses.
  • Shared supply pipes feeding several flats in a converted house.
  • Upper floors in tall buildings without booster pumps.
  • Limescale in taps, shower heads and valves from London’s hard water.
  • Peak-time demand in your street, or a fault on the water company’s mains.

How to test it

  • Time how long the cold kitchen tap takes to fill a 1-litre jug. More than 6 seconds suggests low flow.
  • Ask neighbours whether they have the same problem. If they do, it may be the mains.
  • Check the water company’s website for local works or outages.

Fixes that work

Fully opening or replacing a seized stopcock is often the cheapest win. Replacing a lead supply pipe with modern plastic dramatically improves flow and removes lead from your drinking water. Where the mains is fine but pressure falls off upstairs, a properly specified booster pump or accumulator can help, subject to water company rules. Descaling shower heads and valves fixes many “low pressure” showers.

We test pressure and flow before recommending anything, so you only pay for the fix that will work.

General Plumbing Repairs in London

Frequently asked questions

Can I fit a pump on the mains water?

Pumping directly from the mains is restricted by water regulations. An accumulator or a correctly specified system with a break tank is usually required. Ask a qualified plumber.

Will a combi boiler work with low pressure?

Combis need adequate mains flow to deliver good hot water. We measure flow before recommending one.

Fast response

Need a plumber?

Engineers at your doorstep. Fixed price agreed before any work starts.

07506 605605

Book an engineer · Step 1 of 5

What do you need help with?

Service

Secure · No spam

WhatsApp us